| Description |
LABRATORY
CHARLES POSS HSM-100LH2 HIGH SHEAR MIXER STIRRER LABORATORY WITH 2HP MOTOR THAT RUNS ON 220V SINGLE PHASE VFD HAS A DIGITAL PHASE CONVERTER BUILT INTO THE VFD. THE CONTROLLER WAS CHANGE BECAUSE THERE WAS NOT 3 PHASES IN THE LAB.
PLEASE WATCH THE VIDEO. THE VFD IS CURRENTLY PROGRAMMED WITH A RAMP-UP TIME OF 10 SECONDS, AND IT GOES FULL SPEEDOF 13,000 RPM IN 10 SECONDS. THE MOTOR SPINS AT 220V SINGLE PHASE. THE SYSTEM INCLUDES THE MANUAL FOR THE VFD.
THE 1/2" PORT FOR ADDING MATERIALS TO THE MIXER IS OPEN. IF THAT WAS CLOSED, AIR WOULD NOT BE GETTING INTO THE MIXER BLADE, AND THE WATER IN THE BUCKET WOULD QUICKLY GET SPUN OUT OF THE BUCKET BECAUSE THE AIR WOULD DECREASE THE LEVEL OF VIOLENCE IN THE BUCKET BY CHOPPING AIR INSTEAD OF JUST LIQUID. WITH THE VFD, YOU CAN EASILY CHANGE THE SPEED OF THE MIXER BY JUST CHANGING THE DIAL KNOB. YOU CAN ALSO REPROGRAM THE VFD, SO YOU HAVE TO ENTER THE DESIRED SPEED DIGITALLY IF YOU NEED ACCURATE SPEEDS.
THE AIRLIFT OF THE MIX HEAD WORKS FINE. JUST SWITCH TO RAISE OR LOWER (YOU MUST HAVE AIR SUPPLIED TO THE SYSTEM), THEN PUSH THE TIP AND BOTTOM BUTTONS, AND THE MIXER RAISES OR LOWERS. IT YOU DO N OT HAVE AIR, IT WILL NOT LOWER BECAUSE THERE IS A VALVE THAT NEEDS AIR PRESSURE TO BE CONTROLLED TO RELEASE AIR PRESSURE. IT ALL WORKS AS IT SHOULD, BUT ON THIS SYSTEM, YOU ONLY NEED 220VAC SINGLE PHASE POWR.
THIS SYSTEM HAS A PLACE TO CONNECT A 1/2" TRI-CLAMP, TRI-CLOVER FITTING SO THAT YU CAN ADD PRODUCTS DIRECTLY TO THE HIGH-SHEAR MIXER BLADES.
BY THE WAY, THIS IS THE ONLY 2HP VERSION OF THIS SYSTEM YOU WILL FIND RUNNING ON A SINGLE PHASE BECAUSE I DO NOT THINK THEY HAVE MADE ONE LIKE THIS FROM THE FACTORY.
|